10 Tricks To Help You Resurface Your Kitchen Cabinets

Are your entire kitchen cabinets appearing ancient and outdated?  Want to get freshly discovered kitchen cabinets though the idea of just spending twenty-thousand to obtain cabinets scares you?

Or it’s possible you desire to construct your own kitchen cabinets by following your cabinet woodworking plans.  We are accessible to assist you in either case.  Prior to you getting all new cabinets we would suggest you give the outdated, tired and worn out kitchen cabinets a face lift.

Refacing your cabinets would be a test of your ability to follow cabinet woodworking plans and a fun cabinet woodworking project all in one. For your benefit, we have provided the following tips.

  1. Prior to starting your cabinet woodworking plans, you will need to take the drawers out and doors off the cabinets.  Before leaving to get materials at the store be sure to measure the doors, drawers, and cabinets.  To help you figure out how much materials you need to purchase, draw out the cabinets, doors, and drawers on paper with the measurements you have taken.
  2. Use wood strips or veneers to reface the kitchen cabinets. Wood strips are more durable and should last longer if installed correctly. Veneer is very thin and if any sanding needs to be done then you may sand through the veneer. However, the veneer has a sticky back to it so you won’t want to use wood glue to attach the veneer to the surface of the cabinet.
  3. Replace the old doors with new doors either made by yourself if you are a craftsman or you can purchase new doors all ready to go from your local hardware store.
  4. In the event that your old drawers are not broken and are still usable then we suggest you remove the wood fronts from each of them. Then you can cut new drawer fronts yourself and attach them to the drawers.
  5. For a less expensive project, we would advise you to cover the sides of the old cabinets with plywood such as oak, cherry etc. Plywood costs less and is just as attractive and durable.
  6. Before you begin to resurface the fronts of the cabinets, be sure you have enough wood clamps to deliver equal pressure in all areas of the facing so that when the side and front faces meet you have a good fit.  As a result, you may not have much sanding to do afterward.
  7. Use glue and finish nails to attach plywood. Return and fill in the holes with a mixture of glue and saw dust from the same type of wood you are using to reface your cabinets. You will get a perfect match.
  8. For anyone choosing to use wood strips to face cabinets, make sure to have masking tape or painter tape on hand to help hold the wood strips in place before you start to clamp down. This type of tape does not leave any visible after effects.
  9. Clean up any wood glue that squeezes out to the surface as you begin to tighten down the wood clamps.  It is much easier to clean the glue off when it is wet than to go back and sand down the dried glue. Especially if you are using veneer because the chances of sanding through it are much greater.
  10. Use the correct wood glue. Wood glue is yellow in nature, not white like the kind you used in school when you were a child. It provides a stronger bond than the white glue and is water-resistant.

Yours to use. Ten helpful hints that may help you resurface the ugly kitchen cabinets. Before tackling this project of refacing your cabinets, it would be advisable to further your research by reading and viewing more cabinet woodworking plans. Once you feel confident about what you are doing you will want to tackle this project.

Whichever way you choose to go be it giving your kitchen cabinets a face lift or making your own cabinets from a set of cabinet woodworking plans one item is known. New kitchen cabinets cost a lot of money while refacing the old cabinets may be a bit hard but will save you quite a bit of money.

Leave a Reply

Your email address will not be published. Required fields are marked *